1043828 Miller 72K Downflow FER Gas Furnace 95% AFUE Front Return
Part #MILMG2R072F1ACM2
MFG #1043828
Manufacturer Name : Miller
- 100% fired and tested- All units and each component (both mechanical and electrical) are tested on the manufacturing line
- Clean and quiet operation- Due to the unique design of in-shot burners, location of inducer and use of insulation
- Fixed 30 second blower delay- At burner start-up assures a warm outlet air temperature at furnace start-up.Adjustable blower off settings (60, 90, 120 and 180 seconds)
- Fixed 30-second post purge- Increases life of heat exchanger
- Dependable, hot surface ignitor- Innovative application of silicon nitride type igniter. Utilizes proven Smartlite technology to extend igniter life
- Tubular primary heat exchanger- Heavy gauge aluminized steel heat exchanger assures a long life
- Stainless steel secondary heat exchanger- Assures a long life
- 60 second fixed cooling cycle blower-off delay (TDR)- Increases cooling performance when matched with a Nortek Global HVAC coil
- Sealed combustion approved for direct vent furnace,category IV venting system- May be vertically or horizontally vented using a two-pipe system for maximum flexibility in installation
- LP convertible- Simple burner orifice (included w/unit)and gas valve regulator change for ease of convertibility
- 3 amp fuse protection against low voltage shorts- Protects transformer and control board
- Low voltage terminal board- For easy field wiring
- Easy open pawl latch- Secures the door firmly for transit, yet allows easy removal for access
- Appliance quality door- Protects against rust and other corrosion. Baked enamel finish allows for easy cleaning
- Fully insulated cabinet- Insures minimized heat loss and quiet operation
- Color coded wire harness- Designed to fit the components, all with quick-connect fittings for ease of service and replacement
- Multi-speed ECM blower- Designed to give a wide range of cooling capacities. Switches on PCB, provide ultra easy motor speed selection. 40VA transformer included
- Diagnostic lights for easy troubleshooting without counting flashes- Dedicated light for flame signal strength and 2 lights in combination to indicate all other fault codes with easy to recognize states without counting flashes
- Install Instructions
Specification Sheet - The high efficiency downflow gas furnace is designed for all manufactured housing applications. It may be installed in a utility room, or enclosed in a closet. CSA design certified for use in the United States and Canada.